Plumber in Makkah | Leak Detection, Drain Unblocking and Water Heaters

Plumber in Makkah from Gulf Al-Arab Company comes to your house, apartment or building to find water leaks with detection equipment, unblock drains and floor traps, install and repair water heaters, fit sanitary ware and mixers, and lay supply and drainage pipes for new builds and renovations. An inspection visit starts from SAR 95, drain unblocking starts from SAR 85 and equipment-based leak detection starts from SAR 185. Any other job is priced once the technician has seen the fault and explained what he will do before he starts.

Plumbing in Makkah has its own pattern. Most houses and buildings rely on a ground tank filled from the mains or by a water tanker, a pump that lifts water to a roof tank, and gravity feed from there down to the bathrooms and kitchen. That chain means a small fault in a float valve or a non-return valve can show up as weak pressure on the third floor, or as tanker deliveries you need more often than usual. So our technician starts by understanding the whole route before he touches a single pipe.

Plumber services in Makkah: what does the job cover?

A plumber in Makkah handles everything to do with water coming into the home and water leaving it: from the tank and pump to the last tap, and from the basin to the inspection chamber in the street. These are the main services our team carries out in residential districts, buildings and furnished apartments:

If the problem is mixed, such as water leaking near a socket or inside an electric heater housing, the safe order is to cut the power first and have the electrical part handled by a specialist. That is why you can ask for a home electrician in Makkah to come on the same visit when needed.

Plumber prices in Makkah

Plumber prices in Makkah start from SAR 85 for unblocking a basin or floor trap and vary with the type of fault, the length of the line and how hard it is to reach. The table below shows starting prices for the most common jobs; each starts from the figure shown and is confirmed after the inspection:

The final price depends on a few clear factors: the length of damaged pipe, whether the fault sits behind new tiles that need careful opening, the type of replacement parts you choose, and the number of points in an installation. Parts and materials are charged according to what you buy yourself or what the technician brings after you approve the type and price.

Water leak detection in Makkah without random breaking

Leak detection means pinpointing where water escapes from the network before anything is opened, and with us it starts from SAR 185. Most leaks in Makkah come from pipe joints behind walls, from hot-water lines that expand and contract in the summer heat, from old ground tanks with cracked walls, and from toilet bases or floor traps that have lost their seal.

Signs that you have a leak

• The water meter keeps turning with every tap closed.
• The roof tank empties faster than usual, or the pump runs often for no reason.
• Damp patches or peeling paint at the bottom of a wall or on the ceiling of the floor below.
• A musty smell in the kitchen cabinet or around the basin.
• Tiles lifting or sounding hollow when you walk on them.
• The water or tanker bill rises noticeably without higher use.

How we detect the leak

The technician first closes every outlet and watches the meter for a few minutes to tell whether the leak is on the supply side or the drainage side. He then splits the network by closing the stop valves one by one to find which branch is leaking. Next he uses a ground microphone that picks up the sound of escaping water under the tiles and a thermal camera that shows temperature differences along hot-water lines, and he may pressure-test the suspect branch. Once the point is found, only a small spot is opened, the joint is repaired or the fitting replaced, and the pressure test is repeated before closing up.

Tank leaks are treated differently. The tank is emptied and checked from inside. If the leak comes from the pipe entry or a crack in the wall, it is sealed with materials suitable for drinking-water tanks; if a plastic roof tank has cracked in the sun, replacing it is better than patching it.

Drain and floor-trap unblocking in Makkah

Drain unblocking starts from SAR 85 for a basin or floor trap and is done with an electric drain snake for narrow lines or with water pressure for longer runs. Household blockages usually come from grease building up in the kitchen sink, hair and soap residue in shower traps, and wipes flushed down the toilet. In older buildings the cause can be a horizontal line laid with the wrong fall, so sediment keeps settling in the same place.

The technician first works out whether the blockage is at one point or in the shared line. If only the basin is slow, the problem is in the siphon or the first metres of pipe; if water rises in the floor trap when the washing machine runs, the blockage is further down and the inspection chamber has to be opened. After unblocking, a large volume of water is run to make sure the line drains at a normal speed.

In buildings that use a septic pit instead of the public sewer, water rising in the floor traps can mean the pit is full rather than the line blocked. In that case the pit is emptied by a suction tanker first and the lines are checked afterwards.

Water heater installation and repair in Makkah

Water heater installation in Makkah starts from SAR 140 and repair starts from SAR 65. The job covers the cold inlet, the hot outlet, the safety valve and a check that the unit is properly earthed. Makkah is hot most of the year, yet roof-tank water gets very hot in summer and cools on winter nights, so every home needs a heater that works properly and mixers that blend hot and cold comfortably.

Common heater faults

• Water does not heat: usually a failed element or thermostat, checked with a meter before anything is replaced.
• The breaker trips when it switches on: a sign of current leaking from the element; the heater should stay off until it is fixed.
• Water dripping under the heater: a small amount from the safety valve is normal; a leak from the tank body means replacement.
• A crackling sound: scale built up at the bottom, cleared by draining and flushing the heater.
• Brown water: internal rust, or a magnesium anode that has reached the end of its life.

When choosing a new heater, match the capacity to the number of people: a small storage heater suits one bathroom for two people, while a large family needs more capacity or one heater per bathroom. An instant heater suits basins and kitchens because it gives hot water straight away without a tank, but it needs its own electrical circuit with enough capacity.

Sanitary ware and mixer installation

Mixer installation starts from SAR 95 and toilet repair or a new flush kit starts from SAR 28, while a full bathroom set is priced by the number and type of pieces. The technician fits floor and wall-hung toilets with their concealed cisterns, wall-hung or countertop basins, single and double kitchen sinks, bidet sprays, shower columns and shower cabins, checks that every piece is level and seals each joint with the right silicone.

What spoils a new installation most is haste: a toilet whose base was not fixed firmly starts to rock and then leaks, or a mixer fitted without flushing the line leaves its strainer blocked with construction grit a few days later. So the technician runs the water before fitting the mixer to clear sand and sediment, then fits it, tests it and leaves the piece clean and ready to use.

Plumbing installation for new buildings and renovations

Plumbing installation means laying the supply and drainage network before plastering and tiling. It is priced from the plan and the number of points, so ask for its price at the site visit; small pipe-extension jobs start from SAR 45. A sound installation goes through stages that should never be skipped, because any mistake ends up buried under the tiles and shows later as a leak or a blockage.

• Planning: fixing the position and outlet height of each fixture before cutting, and reviewing it with the owner.
• The right pipes: PPR for hot and cold supply because it handles heat and is heat-fused, and PVC of suitable diameters for drainage.
• Falls: horizontal drain lines need a steady slope towards the inspection chamber so sediment does not settle.
• Stop valves: a main valve for each bathroom and the kitchen, so one part of the house can be isolated for maintenance without cutting water to everyone.
• Pressure test: the network is filled and left under pressure long enough before tiling; any drop on the gauge means a joint to redo.
• Venting: a vent pipe on the drainage stops smells coming back and helps it drain faster.

When renovating old bathrooms, it is better to replace any galvanised steel pipes, since they rust from inside, weaken the flow and change the taste of the water, and to re-plumb the whole bathroom instead of patching parts of it. The bathroom power points and lighting can be renewed at the same time and moved away from splash zones.

Weak water pressure, pumps and tanks

Fixing weak water pressure starts from SAR 140 and covers the pump, the float valve, the valves and the down-feed lines from the roof tank. In Makkah, weak pressure on top floors is common because the roof tank sits just above the last floor and the height difference is not enough for comfortable pressure. The usual fix is a small booster pump after the roof tank or an automatic pressure unit that starts when a tap opens.

• A stuck float in the ground tank makes it overflow or never fill.
• A failed non-return valve makes the pump lose its prime and spin without lifting water.
• Mixers and filters clogged with sediment give weak flow at one point only.
• A narrow down-feed pipe from the roof tank cannot serve several bathrooms at once.

Tanks should be cleaned and disinfected regularly and the roof tank kept under a tight lid that keeps out dust and birds. The sediment that gets into the tank is the same sediment that blocks mixer strainers and shortens the life of heaters.

Plumbing emergencies: what to do until the plumber arrives

In any plumbing emergency, close the stop valve nearest the problem first; that alone prevents most of the damage. Emergencies are not all alike, and each has a quick action that limits the loss until the technician gets there:

Many sewer smells in apartments left closed for a long time come from the water in floor-trap siphons drying out, which opens a path for odours from the network. Pouring a cup of water into each trap usually solves it; if the smell stays, the vent pipe is probably blocked or a siphon is broken and needs replacing.

In furnished apartments and buildings that get busy in the seasons, it pays to check tanks, pumps and heaters a few days before the season starts. Demand on the network doubles as apartments fill up, and a slightly weak pump or a partly blocked shared line can then turn into a fault that cuts water to several apartments at once.

How to book a plumber in Makkah from Gulf Al-Arab

Booking a plumber takes a few short, clear steps, starting with describing the problem and ending with the work being tested in front of you:

• Describe it: contact us through the contact page with your district and the type of problem, ideally with a photo.
• Appointment: we agree a visit time that suits you.
• Inspection: the technician checks the fault and explains the cause, the fix and the price before starting.
• Work: once you approve, the job starts with floors and nearby furniture protected.
• Testing: running the water and testing pressure or drainage in front of you.
• Clean-up: removing work debris and leaving the space as it was.

Makkah districts we serve

We serve residential districts across Makkah, east and west, north and south. Among the districts we reach most often:

Districts: Al Aziziyah, Al Awali, Al Naseem, Al Khalidiyah, Al Otaibiyah, Al Sharaie, Al Nawariyah, Al Kakiyah, Al Zaidi, Wali Al Ahd, Al Shawqiyah, Al Zahir, Batha Quraish, Al Rusaifah, Al Hindawiyah, Al Misfalah, Al Kidwah, Al Maabdah, Al Tayseer.

If your district is not listed, contact us and we will tell you whether we can reach you and when.

Plumbing tips for Makkah homes

The most important tip for Makkah homes is to check the tank and pump every month, because most faults start there and then show up in the bathrooms. These practical tips cut faults and save water:

Why choose a Gulf Al-Arab plumber in Makkah?

We keep it simple: a technician who explains before he works, a price that starts from a clear figure, and work that is tested in front of you. What sets the service apart:

• Diagnosis with equipment rather than guesswork and breaking in several places.
• Technicians who know the ground-tank, roof-tank and pump set-up common in Makkah homes.
• The cause, fix and price explained before any work, with nothing added without your go-ahead.
• Parts and materials whose type you choose, with the differences between them explained.
• An electrician can be arranged when a fault is shared, and you can see our other services in one place.

Whether you have a small leak under the basin or a full bathroom installation in a new annex, the aim is the same: water that runs in your home at comfortable pressure, drains without smells or blockages, and a clear idea of what you paid for.

Article tags

Plumber in Makkah Makkah plumber plumbing Makkah water leak detection Makkah drain unblocking Makkah floor trap cleaning water heater installation Makkah water heater repair sanitary ware installation mixer installation plumbing installation Makkah pipe extension weak water pressure water pumps water tanks Al Aziziyah plumber Al Sharaie plumber Al Awali plumber plumber prices Makkah Gulf Al-Arab Company plumbing maintenance